2011-2019 6.7L Power Stroke Exergy Performance 10mm CP4.2 Pump 

Has your factory pump hit its limit, and you still need more pump capacity? Do you want the capability of more power without the worry of a multi-pump controller failing, a custom length belt breaking or a second pump to worry about? For applications up to 900+HP Exergy's 10mm Stroker CP4.2 pumps are the best option to take your build to the next level.

Pioneering a reliable modified CP4.2 pump did not come easy. Exergy found the limits on a durability test bench, not on customers vehicles. After the initial R&D was complete, each series of pump was subject to one final test in which they ran the pump at 4500 rpms and a pressure that far exceeded what the pumps will see in the field for 40 hours. A final inspection was done after this test to ensure no parts had significant wear. In production, each and every pump is tested throughout the entire operating range of the pump up to 4500 rpm and 29,000 psi to ensure 100% proper function before being installed into a vehicle.

Exergy's CP4.2 pump comes with Exergy's System Saver Inlet Metering Valve installed. This inlet valve replaces the factory single layer 85 micron inlet screen that is molded in a plastic frame with a two layer 10 micron screen which is mounted on a stainless steel frame that will not fail when the screen fills with debris and becomes a restriction. Not only is the screen over eight times finer than the factory screen, but the addition of another layer further increases protection from debris.

Note: It is recommended to use the stock factory lift pump with this CP4.2. It has enough flow with at the target feed pressure to support 900hp. If an aftermarket lift pump is used, it will need a minimum pressure capability of 86psi.

NO CORE CHARGE or CORE RETURNED NEEDED!