2011-2019 6.7L Power Stroke Exergy Performance Improved Stock CP4.2 Pump 

Are you loosing rail pressure from a worn out CP4.2 pump? Are you in need of a factory replacement pump? From stock up to 570+HP Exergy's Improved Stock LML CP4.2 pumps are the best and most affordable solution for an upgraded pump that won't require supporting modifications or tuning. For added flow capability Exergy's Improved Stock CP4.2 pumps are based on new pumps from the 2015-2019 series of 6.7 Power Stroke.

This Improved Stock pump comes with Exergy's System Saver Inlet Metering Valve installed. This inlet valve replaces the factory single layer 85 micron inlet screen that is molded in a plastic frame with a two layer 10 micron screen which is mounted on a stainless steel frame that will not fail when the screen fills with debris and becomes a restriction. Not only is the screen over eight times finer than the factory screen, but the addition of another layer further increases protection from debris.

Based on a number of injector sets they have tested from systems with a failed pump with a System Saver installed it appears that injector survivability is increased more than 85% when compared to pump failures with the factory screen.

Note: It is recommended to use the stock factory lift pump with this CP4.2. It has enough flow with at the target feed pressure to support 900hp. If an aftermarket lift pump is used, it will need a minimum pressure capability of 86psi.

NO CORE CHARGE or CORE RETURNED NEEDED!